B.TECH/ | MBA/ | M.TECH Admissions Open | Help line numbers: 9999889380 / 9999889346 MCA Admissions Open Help line numbers: 8860092369, 9873118682 Email: ahodmca@abes.ac.inExcellent Placements of batch 2012-2016ABES-EC is NIRF Ranked institute ABES has consistently been amongst the top ranked institutes on ranking charts of AKTU.

Online Admission Enquiry Form for Courses

  • B.Tech (Ist Year)
  • B.Tech - Lateral Entry (IInd Year)
  • MBA
  • MCA(Ist Year)
  • MCA - Lateral Entry (IInd Year)
  • M.Tech

Click here...
Admission Queries, Click here...

SlideBar
circulars

 

Research 2016-17

  • Ashish Malik, “Power generation using cotton stalk derived producer gas in diesel engines” in International Journal
  • Mr. Yogesh Chandra, “Some experimental studies on properties of acrylic dielectric elastomers as actuators for artificial muscles” in International Conference
  • Mr Shivam Sharma , “Comparison of results in benchmarking performed through various techniques in an engineering college of Delhi NCR” in International Conference

Research 2015-16

  • Ashish Malik, N.P.Singh, Gaganpreet Kaur, Sharad Bhardwaj, “Use of Agri-waste for the Development of Sustainable Energy Resources” in International Journal
  • Ashish Malik,”Performance Evaluation of an IC Engine Fuelled with Blends of Diesel and Butanol” in International Conference
  • Ashish Malik, “Economic Analysis of Using Different Biomass Fuels In A Dual Fuel Engine” in International Conference
  • Mr. Manish Saraswat, “Effect of butanol in S.I. Engine- A Review” in a National Seminar at IIT Roorkee.
  • Mr Shivam Sharma , “Benchmarking Techniques – A review and exploring suitable techniques to benchmark performance in academia” in International Conference

Research 2014-15

  • Ashish Malik, “Biomass-Based Gasifiers for IC Engines- A Review” in International Journal
  • Ashish Malik, N.P.Singh, “Economic analysis of producing biogas from rural Waste-a case study” in International Conference
  • Manish Saraswat, “Effect of Compression Ratio on Performance and Emissions of Diesel on a Single Cylinder Four Stroke VCR Engine” in International Journal
  • Manish Saraswat, “Assessment of Different Alternative Fuels For Internal Combustion Engine: A Review” in International Journal
  • Anoop Pandey, “An Experimental Investigation to Optimize the Surface Finish for Turning SS 202 Using S/N Ratio and ANOVA Technique” in International Conference

Research 2013-14

  • Mr. Anoop Pandey, Mr. Sandeep Garg & Ms. PayalDamle , “An Experimental Investigation to Optimize the Process Parameters of Surface Finish in Turning AISI 202 stainless steel using Taguchi approach” in an International Journal.
  • Mr. Anoop Pandey, Mr. Sandeep Garg & Mr. Isha Kakkad, “Effect of different coating composition's Rutile-type welding Electrode on undercut defect in manual electric arc welding” in an International Journal.
  • Mr. Anoop Pandey &Mr. Ish Kakkad, “The Effect of Endothermic Material on undercut defect on low carbon stainless steel” in an International Journal.
  • Prof. J.S. Beha l& Mr. Manish Mangal, “Study of slip Plane dislocation in propagation of fracture” in a National Conference.
  • Dr. P.K Agarwal & Prof J.S. Behal, “Drag Reduction of a square cylinder with upstream rod arrangement and its computational Analysis” in a National Conference.
  • Mr. Yadvendra Kumar Mishra, “Defect of Ni Addition on the hardness and tensile strength of AL-CU Alloy prepared by Powder Metallurgy Technique” in an International Conference.
  • Prof. Sandeep Garg & Mr. R.S. Raman, “Design analysis of the roll cage for all terrain vehicle” in an International Journal.
  • Dr. Pk.Agarwal & Mr Manabevdra Saha, “Modeling and analysis of connecting rod” in a National Conference.
  • Mr. Krishna Kr. Karothiya & Mr. Kumar Ankur, “Feasibility analysis of rooftop wind turbine in India” in a National Conference.
  • Mr. Krishna Kr. Karothiya, “Estimation and composition of ocean wave energy for east, south and west coast of India” in a National Conference.
  • Mr. Krishna Kr. Karothiya & Mr. Sanjay Kumar, “Renewable energy generation and conversion for meet India's futuristic need” in a National Conference.
  • Dr. Pk.Agarwal & Mr . Vijay Kr. Gupta, “Mixed convection boundary layer flow along a vertical flat plate” in a National Conference.
  • Dr. Pk.Agarwal, Mr . Vijay Kr. Gupta & Mr. Gaurav Chauhan, “Mixed convection boundary layer flow along a vertical flat plate for Non Newtonian Fluids” in a National Conference.
  • Ms. Lucky Agarwal, Ms. Gaganpreet Kaur & Mr. N.P Singh, “An Introduction to laser igniters Revolution in internal combustion engines” in an International Journal.
  • Mr. Manish Saraswat, “Study on Carbon footprint” in an International Conference.

Research 2012-13

  • Mr. Krishna Kr. Karothiya & Mr. Kumar Ankur, “Design of an integration renewable energy system for a remote village in India” in a National Conference.
  • Mr. Anoop Pandey & Mr. Ish Kakkar, “Study the effect of coating Material on undercut defect in MMAW on SS-304” in an International Journal.
  • Mr. Vijay Kr. Gupta, Mr Manish Mangal & Mr. Gaurav Chauhan, “Mixed convection a vertical plate with uniform wall temperature” in a National Conference.
  • Mr. Krishna Kr. Karothiya & Ms. Lucky Agarwal, “Design of electricity generation system from Ocean wave energy for west coast of India” in an International Conference.
  • Mr. Manish Mangal & Mr. Ashish Malik, “Synthesis AL-Mg Zn Alloys and study of their Mechanical properties” in an International Conference.
  • Mr. Ashish Malik, “Solid Waste disposal in Urban areas:A Threat to environment” in an International Conference.
  • Ms. Gasanpreet Kaur, “Optinization of electrical Energy in Robot using genetic Alorithm” in an International Conference.
  • Ms. Lucky Agarwal, “Effect of variation of silicon and copper contents in Aluminium- silicon alloy” in an International Conference.

Research 2011-12

  • Prof. S.S.S. Govil, Mr. Manish Saraswat & Mr. Vijay Kr. Sharma, “Enhancement of sugar power plant efficiency by employing the condenser pressure” in an International Conference.
  • Prof. S.S.S. Govil, Mr. Manish Saraswat & Mr. Vijay Kr. Sharma, “Promotion of co-generation by optimal analysis of energy utilization in sugar industry” in an International Conference.
  • Ms. Lucky Agrawal, “Effect of Magnesium content on the mechanical properties of AL-Zn-Mg Alloys” in an International Journal.
  • Ms. Gaganpreet Kaur, “Optimization of Robot Trajectory path using genetic algorithm” in a National Conference.
  • Mr. Manish Mangal, “Computational analysis of grag reduction of a cylinder using an upstream circular rod” in a National Conference.
  • Ms. Gaganpreet Kaur & Mr. R.S. Raman, “Minutiae feature based Algorithm for finger print recognition and verification” in an International Journal.